TīmeklisRTX 3080 FE re-padding and re-pasting. Saving the original pads and 16-30C drop in memory temps! I repasted and repadded my RTX 3080 FE 10 days ago and the memory temps have been great since then. Went from 110C at 100% whiny fans (in Control at 4K) to low 90s at 50% fan. Temps can be lower than 90C if fan speed is >80% but … TīmeklisLTV1 tiešraide internetā, vienotajā sabiedrisko mediju atskaņotājā REplay.lv
How to Create an Email Signature on 5 Popular Services
Tīmeklis2024. gada 11. apr. · Skaties un klausies Latvijas Televīzijas un Latvijas Radio saturu vienuviet. Tiešraides, raidījumu ieraksti, programma. TīmeklisOn the GPU Side yes, i changed the thin strip of pads on the VRM, you can see here in the first picture all pads are new.. In the second photo it was before the last repad/repaste, you can see a mix of stock pads (the white ones on the VRMs) and thermalright 2mm (the grey ones) that i added before (see part 2), but were too stiff … camshaft rocker cover
Brake Shoe Reline Procedures - YouTube
TīmeklisFor FULL 3090 FE: I prefer TWO packs of Gelid Extreme 1.5mm for the GPU Core side, and TWO packs of Gelid Ultimate 2.0mm for the backplate side. (Gelid Extreme 2.0mm works as well on the backplate, do not use 2.0mm on core side). This is to make sure you don't run out, and you have a little left over for the future (the PCIE Slot pad is … TīmeklisFor FULL 3090 FE: I prefer TWO packs of Gelid Extreme 1.5mm for the GPU Core side, and TWO packs of Gelid Ultimate 2.0mm for the backplate side. (Gelid Extreme … Tīmeklis2004. gada 21. dec. · Repads for Pressure vessel thread292-110275 Merzi (Mechanical) (OP) 14 Dec 04 10:22 We are fabricating a Pressure which had repads for nozzles and manways. These repads are cut in two pieces and fitted on the nozzles after the full penetration category "D" joint is welded and PT tested. two tell tale holes are also … camshaft sbc